Consisting of the stress balanced gear pump, DC motor, multi-functional manifold, valves, tank, ect., this power unit is created to operate materials managing products. The reducing motion is achived by the solenoid valve using the decreasing velocity controlled by an adjustable needle valve. The left and suitable functions are equipped that has a dual pilot operated verify valve and cross-over relief valves.
Remark: Please seek advice from our sales engineer to the unique pump displacement, motor energy or tank capacity.
1. This electrical power unit is of S3 duty cycle, i.e.,non-continuous operation,30 seconds on and 270 seconds off.
2. Clean all the hydraulic components concerned ahead of set up of the power unit.
3. Viscosity from the hydraulic oil shoud be 15~46 cst, which really should also be clean and cost-free of impurities.N46 hydraulic oil is suggested.
4. This electrical power unit need to be mounted horizontal.
5. Check the oil level within the tank just after the primary start out with the electrical power unit.
six. Oil shifting is needed following the first a hundred operation hrs, afterwards after just about every 3000 hrs.