Electrical power UNITS FOR LIFT TABLE one
Standard Description
This electrical power unit is intended exclusively for the compact lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has been extensively utilised while in the marketplace of logistic products such as minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed through the solenoid valve together with the pace managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Basic Description
This energy unit is designed exclusively for your medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve and the pace managed through the adjustable needle valve. When the lift rises to a high positoin, but the power provide is minimize, the decreasing movement is controlled by the guide override function.
Power UNITS FOR LIFT TABLE 3
Basic Description
This power unit is developed exclusively for that big lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve and also the velocity controlled by a stress compensated flow manage valve.
Power UNITS FOR LIFT TABLE four
Common Description
This electrical power unit is developed solely to the massive lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve along with the velocity controlled by the adjustable needle valve. Once the lift rises to a large positoin, but the energy provide is minimize, the decreasing motion is controlled from the guide override perform.
Specific Notes
1. This power unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the 
hydraulic elements concerned ahead of installation of the electrical power unit.
3. Viscosity of the oil shoud be 15~46 cst,which really should also be clean and free of charge of impurities.N46 hydraulic oil is advised.
four. Oil modifying is needed immediately after the first one hundred operation hrs,afterwards once every 3000 hrs.
five. The power unit proven is built to be mounted vertically.
