Material Dealing with Power UNIT two
Basic Description
This energy unit capabilities power up gravity down circuit. Activate the start solenoid to begin the motor to lift the machine. The lowing motion is activated through the solenoid valve with the decreasing pace managed by the stress compensated movement management valve. Merchandise of this series could be widely used in the business of logistic gadgets such as fork lift, mini lift table, and so forth.
Special Notes
one. The duty of this power unit is S3,i.e.,thirty seconds on and 270 senconds off.
2. Clean all of the hydraulic parts concerned before mounting the energy unit.
3. Viscosity with the hydraulic oil shoud be 15~46 cst,which must also be clean and free of charge of impurities, N46 hydraulic oil is suggested .
four. Oil modifying is required right after the first one hundred operation hours,afterwards once just about every 3000 hours.
five. The power unit ought to be mounted horizontally.

Materials Handling Power UNIT 1
Basic Description
This energy unit is developed for the fork lift sector, consisting of very productive gear pump, DC motor, manual increase and decrease valve, tank, ect. The up and down motion are controlled by the lever in the guide release valve, and that is equipped with an electric switch to activate the motor. The lowing speed is managed by the stress compensated movement control valve.
Special Notes
one. The duty of this energy unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean each of the hydraulic parts concerned prior to installation of the energy unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst, which ought to also be clean and cost-free of impurities, N46 hydraulic oil is advisable .
four. Oil modifying is needed following the initial a hundred operation hours, afterwards when just about every 3000 hours.
five. The electrical power unit shown is created to be mounted horizontally.